Our Over the Shoulder Harness is designed and tested to meet FMVSS-213 standard, along with FMVSS-302 flammability requirements. The Harness must be used with an existing lap belt in order to meet the FMVSS-213 Standard.

Part No:

• Y8103-1AHB: Adult Hi Back
• Y8103-1ALB: Adult Low Back
• Y8103-1CHB: Child Hi Back
• Y8103-1CLB: Child Low Back

The Over the Shoulder Harness is an added way to give extra upper body support when being transported in a school bus.

Over the Shoulder Harness Installation:

Unbuckle existing vehicle seat belt, lift bench seat and insert the tongue part of the buckle end between seat cushion and backrest, leaving the 1 1/2” webbing (crotch strap) lay on the seat cushion. Lay the two looped ends over the top on the seat back.

Buckle the unit on the backside of the seat back.

Place the passenger in the seat; the crotch strap should be between the legs. Thread the lap belt through the first loop then through the crotch strap loop, then through the remaining loop, buckle unit. Pull adjusting strap on seat back snug, and affix excess strap end.

**Recommended replacement after 5 years in service.**